Nuke AN10 to AN10 Male Pressure Gauge Adapter, 1/8 NPT (Order in)

Nuke AN10 to AN10 Male Pressure Gauge Adapter, 1/8 NPT (Order in)*NOTE* Currently is an order in product from Nuke In Sweden. Takes Roughly 3 4 weeks to order in Check out the Nuke website to see what else they offer and more info https: www. nukeperformance. com Listing is for: 1x Pressure Gauge Adapter Full flow AN to AN adapter with a 1 8 NPT threaded pressure port in the middle. It is made to mount a pressure gauge or pressure sensor anywhere on your fuel line. Male to male adapter, equipped with the standard 1

4) Pillow ball upper mount on front & rear

Hardware is included

these catch cans are set to perform under all conditions and for any horsepower requirement

~ After drilling the floor panel as shown in the site gallery

The 50mm (2") fuel filler hose kit

But for an even easier way

most Wilwood calipers use 1/8NPT fittings

approved for 700-2000hp+

1x Fender roller

You can either weld it to your aluminum cell or copy the pattern to your top sheet and bolt the CFC Unit to it putting the top sheet in between the flange and the CFC Unit

this is the most effective way to assemble your fittings and hose ends for your oil

1pc = 10m / 32